G-16
GL6000, GL7000, GL9000, GL11000, WSM
G GENERAL
[3] CHECK POINT OF EVERY 50 HOURS
Checking Fuel Hose and Clamp Bands
• Stop the engine when attempting the check and change
prescribed below.
• Remember to check the fuel line periodically. The fuel line
is subject to wear and aging, fuel may leak out onto the
running engine, causing a fire.
1. Check to see that all fuel lines (2) and hose clamps (1) are tight
and not damaged.
2. If fuel lines (2) and hose clamps (1) are found worn or damaged,
replace or repair them at once.
3. The fuel line (2) is made of rubber and ages regardless of period
of service. Replace the fuel line (2) together with the hose clamp
(1) every two years and securely tighten.
4. However if the fuel lines (2) and hose clamps (1) are found
damaged or deteriorated earlier than two years, then change or
remedy.
• When the fuel line is disconnected for change, close both
ends of the fuel line with a piece of clean cloth or paper to
prevent dust and dirt from entering. Entrance of dust and
dirt causes malfunction of the fuel injection pump. In
addition, particular care must be taken not to admit dust and
dirt into the fuel pump.
W1035921
[4] CHECK POINT OF EVERY 100 HOURS
Changing Engine Oil
• Be sure to stop engine before changing engine oil.
1. After warming up, stop the engine.
2. Place an oil pan underneath the engine.
3. Remove the oil drain plug (1) to drain the dirty engine oil
completely.
4. Inspect the drain plug gasket. Replace it damaged.
5. Reinstall the drain plug.
6. Fill the new engine oil up to the upper mark on the gauge.
• When using an oil of different maker or viscosity from the
previous one, drain an old oil.
• Never mix two different types' of oil.
• Use the proper SAE Engine oil according to ambient
temperatures.
Refer to "4. LUBRICANTS, FUEL AND COOLANT" (G-9).
W1014131
(1) Hose Clamp (2) Fuel Line
(1) Oil Drain Plug [A] GL6000, GL7000
[B] GL9000, GL11000
To Next Page
Loading...
Need help?
General
