Kubota GR2020G User Manual

OPERATING THE ENGINE16
JUMP STARTING
To avoid serious injury:
A Keep cigarettes, sparks, and flames away from
battery.
A If machine battery is frozen, do not jump start
engine.
A Do not connect other end of negative (-) jumper
cable to negative (-) terminal of machine
battery.
When jump starting engine, follow the instructions below
to safely start the engine.
1. Bring helper vehicle with a battery of the same voltage
as disabled machine within easy cable reach. "THE
VEHICLES MUST NOT TOUCH".
2. Apply the parking brakes of both vehicles and put the
shift levers in neutral. Shut the engine off.
3. Put on safety goggles and rubber gloves.
4. Ensure the vent caps are securely in place.
(if equipped)
5. Attach the red clamp to the positive (red, (+) or pos.)
terminal of the dead battery and clamp the other end
of the same cable to the positive (red, (+) or pos.)
terminal of the helper battery.
6. Clamp the other cable to the negative (black, (-) or
neg.) terminal of the helper battery.
7. Clamp the other end to the engine block or frame of
the disabled machine as far from the dead battery as
possible.
8. Start the helper vehicle and let its engine run for a few
moments. Start the disabled machine.
9. Disconnect the jumper cables in the exact reverse
order of attachment. (Steps 7, 6 and 5).
A This machine has a 12 volt negative (-) ground starting
system.
A Use only same voltage for jump starting.
A Use of a higher voltage source on machine could
result in severe damage to machine electrical system.
Use only matching voltage source when "Jump
starting" a low or dead battery condition.
HIGH ALTITUDE OPERATION
[GR2020G]
Operating the engine with the wrong engine configuration
at a given altitude may increase its emissions and
decrease fuel efficiency and performance.
To ensure correct engine operation at altitudes above
1219 meters (4000 ft.), it may be necessary to have an
authorized KUBOTA dealer install a special high-altitude
jet kit in the carburetor. If a high-altitude kit has been
installed, the engine must be reconverted to the original
jet size, before it is operated at lower altitudes, or
overheating and engine damage can result.
(1) Dead battery
(2) Jumper cables
(3) Engine block or frame
(4) Helper battery
Connect cables in numerical order.
Disconnect in reverse order after use.

Kubota GR2020G Specifications

General

Brand	Kubota
Model	GR2020G
Category	Lawn Mower
Language	English