EasyManuals Logo

Kubota GR2020G User Manual

Kubota GR2020G
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #82 background imageLoading...
Page #82 background image
65PERIODIC SERVICE
A To prevent extensive engine wear or damage, always
maintain the proper oil level in the crankcase. Never
operate the engine with the oil level below the "L" mark
or over the "F" mark on the dipstick.
BReplacing Transmission Oil Filter
Cartridge
To avoid serious injury:
A Be sure to stop the engine and remove the key
before changing the oil filter cartridge.
A Allow transmission case to cool down
sufficiently; oil can be hot and may cause
burns.
1. The oil filter cartridge must be changed every 200
service hours.
2. Remove rear cover.
3. Remove the oil filter cartridge by using the filter
wrench.
4. Lightly tighten the screw (A) by using a screwdriver.
5. Apply a slight coat of oil onto the gasket of new filter.
6. To install the new cartridge, screw it in by hand. Over
tightening may cause deformation of the rubber
gasket.
7. After the new cartridge has been replaced, the
transmission fluid level normally lowers a little. Add
fluid to proper level. Check for oil leaks around filter
gasket.
8. Assemble the rear cover.
A To prevent serious damage or premature failure to the
hydraulic system, the replacement filter must be a
highly efficient, 10 filter. Use only a genuine
KUBOTA filter or its equivalent.
(1) Rear cover
(1) Transmission oil filter cartridge
(1) Transmission oil filter cartridge (2) Gasket

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota GR2020G and is the answer not in the manual?

Kubota GR2020G Specifications

General IconGeneral
BrandKubota
ModelGR2020G
CategoryLawn Mower
LanguageEnglish

Related product manuals