Safet
rules
W9212-8235-4
03/2019
27
Fire protection
The excavator components and attachments (in particular the engine and the exhaust system)
reach high temperatures even at normal working conditions. An electric installation which is
damaged or not properly serviced may lead to flashovers and/or electric arcs. The following Fire
Protection Guidelines may help you ensure the maintenance and efficiency of your equipment
and minimize fire hazards.
Remove any accumulated dirt adjacent to hot components, e.g. engine, muffler, exhaust manifold/tubes,
etc. If the machine is being used to full capacity, the cleaning procedure should be performed more fre-
quently.
Accumulated residues from plants and trees, or any other flammable materials, should be removed from
the machine. This must be observed in particular in the proximity of the engine and the exhaust system,
but also at the swivel frame, the track frame, and the boom.
Check the condition and wear of all fuel lines and hydraulic hoses. Any defective parts should be replaced
immediately in order to avoid leakage.
Electric lines and connections must be checked regularly for signs of damage. Damaged components and
lines must be replaced or repaired before starting up the machine. All electric connections must be kept
clean and solid.
Exhaust pipes and mufflers must be checked daily for leaks, damage and any loose or missing joints.
Leaking or damaged exhaust system components must be replaced or repaired before starting up the ma-
chine.
Always keep a multipurpose fire extinguisher at or close to the machine. Make yourself familiar with the op-
eration of the fire extinguisher. In the event of fire in the electrical or hydraulic system, use a CO
2
fire extin-
guisher to combat the fire.
A fire extinguisher is not included in the basic equipment of the machine.
To Next Page
Loading...
Need help?
General
