PERIODIC SERVICE84
BAdjusting Parking Brake Lever
1. Raise the parking brake lever to the parking position
while counting the ratchet sound made by the parking
brake lever.
2. If adjustment is needed, loosen the lock nut and adjust
the parking brake cable length with in acceptable limit.
3. Retighten the lock nut.
EVERY 200 HOURS
BReplacing Hydraulic Oil Filter
C Cleaning Magnetic Filter
To avoid personal injury:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Remove the two oil filters.
2. Clean off metal filings with clean rags at the magnetic
filters.
3. Put a film of clean transmission oil on rubber seal of
new filters.
4. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
5. After the new filter has been replaced, the
transmission fluid level will decrease a little. Make sure
that the transmission fluid does not leak through the
seal, and check the fluid level.
Top up if necessary.
Proper parking brake
lever free travel
2 notches (Ratchet sound 2).
(1) Parking brake lever
(2) Lock nut
(1) Hydraulic Oil filter
To Next Page
Loading...
Need help?
General
