93PERIODIC SERVICE
BChanging Front Axle Gear Case Oil
1. To drain the used oil, remove the right and left drain
plugs and filling plugs at the front axle gear case and
drain the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
3. Fill with the new oil up to the filling plug port.
(See "LUBRICANTS" in "MAINTENANCE" section.)
4. After filling reinstall the filling plugs.
BAdjusting Front Axle Pivot
If the front axle pivot pin adjustment is not correct, front
wheel vibration can occur causing vibration in the steering
wheel.
C Adjusting procedure
Loosen the lock nut, screw-in the adjusting screw until
seated, then tighten the screw with an additional 1/6 turn.
Re-tighten the lock nut.
BAdjusting King-pin Pivot
Loosen the lock nut and tighten the adjusting screw with
following torque:
BChanging Brake Oil
Consult your local KUBOTA Dealer for this service.
Oil capacity 3.5 L for each side
(1) Drain plug
(2) Filling plug
(1) Adjusting screw
(2) Lock nut
Adjusting screw 4.9 to 9.8 N-m, 0.5 to 1.0 kgf-m
Lock nut 98.1 to 147 N-m, 10 to 15 kgf-m
(1) Adjusting screw
(2) Lock nut
To Next Page
Loading...
Need help?
General
