EasyManuals Logo

Kubota ZD1211-AU User Manual

Kubota ZD1211-AU
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
mower deck. Use caution whenever mowing
without the skids attached.
Mowing without the skids must be done only in
locations that are completely flat.
1. Removing the skid
WARNING
To avoid serious injury or death:
Park the machine on a firm and level surface.
Apply the parking brake.
Stop the engine and remove the key.
1. Dismount the mower deck.
(See DISMOUNTING THE MOWER DECK on page
25.)
2. Stand up the mower deck.
3. Remove 4 bolts as shown in the figure and remove
2 skids.
4. Mount the mower deck.
(See MOUNTING THE MOWER DECK on page
24.)
(1) Skid
(2) Bolt
(3) Nut
(4) Spring washer
(A) Mower deck
PREVENTING GRASS
CLIPPINGS AND DUST FROM
SCATTERING
RCK60R, RCK72R
NOTE :
Never remove the rubber plates off the mower
deck.
Grass clippings will scatter and pile up to the
hood and surrounding area during mowing.
Continuous mowing under these conditions
may result in overheating. This machine is
equipped with an overheat warning buzzer as
standard.
Even when the rubber plates are installed, clean
the areas around the hood and the transmission
at a minimum once every 5 hours.
(See Checking and cleaning radiator screen and
hood screen on page 60.)
Be aware that when mowing with the rubber
plates installed onto the rear of the mower deck,
the cut grass will be left in even clearer lines
than usual.
1. Rubber plates installation
WARNING
To avoid serious injury or death:
Park the machine on a firm and level surface.
Apply the parking brake.
Stop the engine and remove the key.
1. Dismount the mower deck.
(See DISMOUNTING THE MOWER DECK on page
25.)
2. As shown in the figure, use 3 short square neck
bolts and 3 flange nuts to install the rubber plate 2
and upper plate 2 onto the rear center of the mower
deck. Tighten the bolts securely.
3. As shown in the figure, use 6 short square neck
bolts and 6 flange nuts to install the 2 rubber plates
1 and the 2 upper plates 1 onto both sides of the
mower deck. Tighten the bolts securely.
 OPERATING THE MOWER TREATMENT OF MOWER DECK INSIDE SKID
48
ZD1211,ZD1221

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota ZD1211-AU and is the answer not in the manual?

Kubota ZD1211-AU Specifications

General IconGeneral
BrandKubota
ModelZD1211-AU
CategoryLawn Mower
LanguageEnglish

Related product manuals