EasyManuals Logo

Kubota ZD1211-AU User Manual

Kubota ZD1211-AU
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
Never operate the engine without heat shields
or guards.
IMPORTANT :
The air intake area must be clear of debris to
prevent the engine from overheating.
Daily or after every 5 hours of operation, check to be
sure the radiator screen and the hood screen are clean.
Dirt or chaff on the radiator screen, hood screen or
radiator decrease cooling performance.
1. Remove the radiator screen and the hood screen,
and remove all foreign material.
2. Remove the dust from between the fins and the
tube.
3. Tighten the fan drive belt as necessary. Details
regarding this procedure can be found in a different
section.
(See Adjusting fan drive belt tension on page 71.)
4. If the scale forms in the tube, clean with the scale
inhibitor or its equivalent.
5. Each time the hood screen is covered with grass
during operation, rub it off the screen with the hand.
Check the radiator screen from time to time if grass
accumulates.
6. If the dust or chaff has accumulated inside of the
hood, remove the radiator screen and clean inside
completely.
After cleaning, replace the radiator screens
properly.
7. Check the radiator for dust or chaff build up.
If the dust or chaff has accumulated in the radiator,
clear with air pressure (not to exceed 30 psi) or a
hose.
(1) Radiator screen
(1) Hood screen
6. Checking the tire pressure
WARNING
To avoid serious injury or death:
Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
Always maintain the correct tire pressure.
The inflation pressure in the front tires rises
quickly when using compressed air.
Do not inflate the tires above the recommended
pressure shown in the operator's manual.
IMPORTANT :
Do not use tires larger than specified.
6.1 Inflation pressure
Even though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course
of time. Therefore, check it everyday and inflate as
necessary.
Tire sizes
Recommended inflation
pressure
Front
15 × 6.5 to 8, Smooth sem-
ipneumatic low profile tire
Rear
26 × 12.0 to 16, 4PR turf
low profile tire
83 kPa
0.84 kgf/cm
2
12 psi
LUBRICANTS, FUEL AND COOLANT  PERIODIC SERVICE
ZD1211,ZD1221
61

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota ZD1211-AU and is the answer not in the manual?

Kubota ZD1211-AU Specifications

General IconGeneral
BrandKubota
ModelZD1211-AU
CategoryLawn Mower
LanguageEnglish

Related product manuals