Appendix
A-16
Paper
General Guidelines
The machine is designed to print on standard copier paper (the type used in ordinary dry copier machines), but it can also
accept a variety of other types of paper within the limits specified below.
Selection of the right paper is important. Using the wrong paper can result in paper jams, curling, poor print quality, and
paper waste, and in extreme cases can damage the machine. The guidelines given below will increase the productivity of
your office by ensuring efficient, trouble-free printing and reducing wear and tear on the machine.
Paper Availability
Most types of paper are compatible with a variety of machines. Paper intended for xerographic copiers can also be used
with the machine.
There are three general grades of paper: economy, standard, and premium. The most significant difference between grades
is the ease with which they pass through the machine. This is affected by the smoothness, size, and moisture content of
the paper, and the way in which the paper is cut. The higher the grade of paper you use, the less risk there will be of paper
jams and other problems, and the higher the level of quality your printed output will reflect.
Differences between papers from different suppliers can also affect the machine’s performance. A high-quality printer
cannot produce high-quality results when the wrong paper is used. Low-priced paper is not economical in the long run if it
causes printing problems.
The recommended basis weight is:
• Cassette: 60 to 120 g/m²
• MP tray: 60 to 220 g/m², 230 g/m² (Cardstock)
• PF-4100: 60 to 120 g/m²
Paper Specifications
The following table summarizes the basic paper specifications. Details are given on the following pages.
Note
The manufacturer assumes no liability for problems that occur when paper not satisfying these requirements
is used.
Item Specification
Weight Cassette, PF-4100: 60 to 120 g/m²
MP Tray: 60 to 220 g/m², 230 g/m² (Cardstock)
Dimensions Refer to Paper Sizes on page A-18
Dimensional accuracy ±0.7 mm (±0.0276 inches)
Squareness of corners 90° ±0.2°
Moisture content 4 % to 6 %
Pulp content 80 % or more
To Next Page
Loading...
Need help?
General