2-25
Installing and Setting up the Machine > Network Setup
2 Select the network name (SSID) appeared in step 5 from the list.
3 Enter the password that was provided in step 5 > [Connect]
The network between this machine and the handheld device is configured.
Configuring the Connection by Using Push Button
When your computer or handheld device does not support Wi-Fi Direct but supports WPS, you can configure the
network using push button.
1
Display the screen.
[System Menu/Counter] key > [ā²] [ļ±] key > [System/Network] > [OK] key > [ā²] [ļ±] key >
[Network Setting] > [OK] key > [ā²] [ļ±] key > [Wi-Fi Direct Set] > [OK] key > [ā²] [ļ±] key >
[Wi-Fi Direct] > [OK] key
2
Configure the settings.
[ā²] [ļ±] key > [On] > [OK] key
3
Restart the network.
[System Menu/Counter] key > [ā²] [ļ±] key > [System/Network] > [OK] key > [ā²] [ļ±] key >
[Network Setting] > [OK] key > [ā²] [ļ±] key > [Restart Network] > [OK] key > [Yes]
4
[Wi-Fi Direct] key > [ā²] [ā¼] key > [PushButton Setup] > [OK] key
5
Press the push button on the computer or handheld device and
select [Push Button] on the screen of operation panel
simultaneously > [Next].
The network between this machine and the computer or handheld device is configured.
You can connect up to three handheld devices at the same time using Wi-Fi Direct setting. When the devices
that support Wi-Fi Direct are connected, if you want to connect other device, disconnect the already-
connected devices from the network. The disconnection methods are as follows:
ā¢ Disconnect the network from the computer or handheld computer
ā¢ Disconnecting all devices from the network on the operation panel
Select [Wi-Fi Direct] key > [ā²] [ā¼] key > [ConnectionStatus] > [OK] key > [Menu] > [ā²] [ā¼] key >
[Disconnect All] > [OK] key
ā¢ Configuring auto disconnecting time from the System menu
Wi-Fi Direct Set (page 8-7)
ā¢ Configuring auto disconnecting time from the Command Center RX
Command Center RX User Guide
To Next Page
Loading...
Need help?
General
