Accounting System Settings Guide
Chapter 2 Setting Up the Accounting System
27
ACLR-Auto CleaR
managemet
Function
This command sets whether or not the front panel menus of the Accounting function
are automatically cleared.
Command/Parameters
Examples of Use
The following sets the auto clear operation to OFF:
!R! ACNT “DMN”, “123456789012345”;
ACNT “ACLR”, “MAIN”, 0;
ACNT “EDAD”;EXIT;
The following sets the time until the auto clear operation is executed to 30 seconds:
!R! ACNT “ADMN”, “123456789012345”;
ACNT “ACLR”, “IME”, 6;
ACNT “EDAD”;EXIT;
Description
• MAIN: auto clear MAIN switch
• TIME: TIME until auto clear
• The auto clear operation can be set between the ACNT “ADMN”..., and ACNT
“EDAD”; commands.
• The time setting will not take effect if the auto clear operation is OFF.
• The setting of the auto clear operation is not related to the setting of the auto clear
operation for normal menus other than for accounting.
• This setting applies only to menus that are called up by entering an administration
ID and does not apply to menus accessed by entering account codes during e-MPS
job output, even if such menus are related to the Accounting function.
Command ACNT “ACLR”, #1, #2;
Parameter #1 “MAIN”: Auto clear ON/OFF
“TIME”: Time until auto clear operation is executed
#2 #1: “MAIN” Default value: 1
0: OFF
1: ON
#1: “TIME” Default value: 12
1-54: Time until auto clear operation is executed (units
of 5 sec.)
To Next Page
Loading...
Need help?
General
