Kyocera KM-NET Manual

Accounting System Settings Guide
Chapter 2 Setting Up the Accounting System
23
Description
• Because this is the switch for the entire Accounting function, even if the account
code, the maximum number of copy and other parameters are set up, settings made
will not take effect unless this switch is set to ON.
• Even if this switch is OFF, settings such as the registration of an account, the
maximum number of copy or other can be performed.
• The Accounting function can be set to ON/OFF between the ACNT “ADMN”; and
ACNT”EDAD”; commands.
• If the number of registered accounts is 0, the Account Management function cannot
be set to ON.
SECR-accounting
SECuRity level
Function
This command sets the security level of the Accounting function.
Command/Parameter
Example of Use
The following sets the security level of the Accounting function to 1:
!R! ACNT “ADMN”, “123456789012345”;
ACNT “SECR”, 1;
ACNT “EDAD”;EXIT;
Description
• The security level setting is valid for SNMP access. (For details, refer to the SNMP
Specifications.)
• The security level can be set between the ACNT “ADMN”; and ACNT “EDAD”;
commands.
CTMD-CounT MoDe
Function
This command sets the count method for each paper size.
Command/Parameters
Command ACNT “SECR”, #1;
Parameter #1 Default value: 0
0-1: Security level
Command ACNT “CTMD”, #1, #2, #3;
Parameter #1 “SIZE”: By paper size
“BLPG”: Number of pages/sheets
#2 #1: “SIZE” Paper size (Numbers are in accordance with SPSZ. See
the table on page 25.)
#1: “BLPG” Fixed at 0 (Don’t care)
#3 #1: “SIZE” See the table below for a list of default values by paper
size.
1: Single count
2: Double count
#1: “BLPG” Default value: 0
0: Count using the number of pages
1: Count using the number of sheets

Kyocera KM-NET Specifications

General

Brand	Kyocera
Model	KM-NET
Category	Printer
Language	English