Accounting System Settings Guide
Chapter 2 Setting Up the Accounting System
9
7Press [ENTER] again. ? blinks on the operator panel.
8 Press [ ] or [ ] to change the setting to On, then press [ENTER]. Account
Management is now set to On.
9Press [MENU]. Ready is displayed again on the operator panel.
•If Sleeping (sleep mode) appears on the operator panel, press [GO]. After a
while, the display changes to Ready.
• If the accounting menu is open without any key input for approximately 60 seconds,
the printer display is automatically restored to Ready.
• In order for the Account Management feature to be turned ON (Step # 6 of "Entering
Settings through the Printer Operator Panel) and Account Code must first be registered .
If you enter the wrong number
If you enter the wrong number, delete the incorrect entry and enter the correct one. To
do this, move the cursor one space to the right of the entry you want to delete, then
press [ ]. The entry is deleted and the cursor moves one space to the left. A black
square () appears in the space where the entry was deleted.
To delete all inputs entered, press [CANCEL]. When you press [CANCEL], all
entered digits are deleted and replaced by black squares (), and the cursor moves to
the far left.
Add Account Code Adds an account code that is permitted to use the printer. An account code must be
registered in advance in order to use the accounting system.
Account codes are numbers of up to eight digits in length. As many as 100 account
codes can be registered.
If one account code contains the same numbers as another account code but has a
different number of digits, then it is registered as a separate account code.
For example, 1 and 001 are registered as separate account codes.
1Display Account Management on the operator panel to access the accounting
system menu. (Refer to Set Account Management ON/OFF on page 8.)
Account >
Management ? Off
Account >
Management ? On
Ready
To Next Page
Loading...
Need help?
General
