Table of Contents
2
Access levels 19
General Information 5 - 15
Entering the password 19
Validity of these instructions 5
Changing password 20
Standards 5
Changing parameters 20
For your safety 6
List of parameters
Follow the legislation on safety of appliances 6
(level 0 and 1 parameters only) 21 - 29
Purpose 7 - 8
Leakage test 30 - 31
Intended purpose of FMS 4 / FMS 5 7 - 8
Mode of operation
Application-internal output regulator (optional) 8
Integrated leakage test (option)
Application-internal O regulator (optional) 10
2
Leakage test flow chart 30
Integrated leakage test (option) 30
Using these instructions 9 - 10
Purpose of these instructions 9
Venting
Preliminary clarification 9
Leakage test line over-roof 31
Finding the appropriate section 9
Calculation formula 31
Conventions 9 - 10
Suggested circuit for venting the gas line
Fault correction 10
over-roof in conjunction with the
combustion management system 31
FMS Operating principle 11 - 15
FMS digital inputs 11
Output regulator (optional) 32 - 38
FMS operating sequence 11 - 12
Pre-ventilation suppression
Method of operation 32 - 34
through an external signal 12
Procedure description 32
Automatic pre-ventilation suppression 12
Weather control 32
Setting the pilot burner, serving mode 13
Set-point switch-over 33
Program monitoring time 13
Startup circuit 33
Restarting 13
Thermostat and control region 34
Leakage test (option) 13
Manual control 34
4 curve sets (option) 13
Flying curve change (option) 13
Setting the regulator 35 - 38
Automatic fuel change 13
Interpreting the display 35
Range limits 13
Control region 35
Internal load 14
Regulator behaviour 36 - 38
Manual operation 14
Examples 38
Parameterisation 14
Correction 14
Before commissioning 39
Facility for direct connection
of Namur transmitter (option) 14
Adjusting motor limit switch 39
Freedom from error of feedback signals 14
Pre-ventilation limit 14
FMS Commissioning 40 - 72
Energy-saving mode for running text display 15
Function test 40 - 41
Separate ignition point 15
Significance of FMSdigital input display 41
Integrated power control unit (option) 15
Integrated O regulation 15
2
Setting control elements 42
Operation of control elements for potentiometer
Settings 16 - 30
adjustment and limit switch settings 42
Inputs 16 - 18
Programming curves 43 - 48
Significance of ID number 16
Programming the compound 43
Inputs 16
Entirely new curve, clear memory 43
Configuration sticker 16
st
Programming 1 point
Configuration number 16
(separate ignition point) 44
Condition on delivery 17 - 18
Programming with burner running 44 - 45
Assignment of sockets to inputs 17
Programming with burner stationary 45
Configuration cards (examples) 17
nd th
Programming 2 to 19 point 45
Processor card 18
Programming last top point 46
Power supply card 18
Store curve 46
Plug-in p.c. card for a continuous output 18
Check monitoring values 46
Adding points 47
Parameters 19 - 20
Changing curve point 48
Parameter setting 19
To Next Page
Loading...
Need help?
General
