Settings List of Parameters
(Level 0 and 1 parameters only)
_____________________________________________________________________________________________________
Para- Short Safety Lower Upper
meter- design- level limit limit Standard
No. nation Description values Aids
_____________________________________________________________________________________________________
Pre-ventilation
346 VO LimK1 1 0 999 Limit to which pre-ventilation can be 999 P4
terminated, Channel 1
347 VO LimK2 1 0 999 Limit to which pre-ventilation can be 999 P4
terminated, Channel 2
348 VO LimK3 1 0 999 Limit to which pre-ventilation can be 999 P4
terminated, Channel 3
349 VO LimK4 1 0 999 Limit to which pre-ventilation can be 999 P4
terminated, Channel 4
350 VO LimK5 1 0 999 Limit to which pre-ventilation can be 999 P4
terminated, Channel 5
Running direction
374 Laufr.K1 1 0 999 Channel 1 running direction in event or fault 2 P6
375 Laufr.K2 1 0 15 Channel 2 running direction in event or fault 2 P6
376 Laufr.K3 1 0 15 Channel 3 running direction in event or fault 2 P6
377 Laufr.K4 1 0 15 Channel 4 running direction in event or fault 2 P6
378 Laufr.K5 1 0 15 Channel 5 running direction in event or fault 2 P6
427 Vodel R 1 0 999 750 P71
When changing the parameters via interface (by means of optional PC software) a check must then be made on
the spot to ensure that the changes have been properly accepted. This can be done by reading out the
parameters on the unit or by comparing the unit's checksums. See page 78 .
0 = OFF (control element stops)
1 = Control element runs OPEN
2 = Control element runs CLOSED
3 = Control element runs to the setting
6 = Control element runs to its ignition point
8 = Control element runs to base load
Re-circulation delay time (on FMS)
No. of air duct points (VMS)
21
To Next Page
Loading...
Need help?
General
