Lantronix EDS4100 Reference Manual

3: Summary of CLI Commands
EDS Device Servers Command Reference 31
Line Menu
The following configurable parameters reside in the Line 1, Line 2, Line 3, Line 4 (and so
forth) configuration menus. These commands configure the corresponding serial ports.
Line Menu Command Description
auto show statistics
Continuously displays line statistics.
clear line counters
Sets the serial counters to zero.
clrscrn
Clears the screen.
command mode always
Sets command mode to always enabled.
command mode echo
serial string
Enables echoing of serial data at boot time.
command mode serial
string
Sets Command mode to use serial settings.
command mode serial
string <string>
Sets the Command mode serial string using ASCII characters.
command mode serial
string binary
<string>
Sets the Command mode serial string using binary values.
command mode signon
message <string>
Sets the boot-up sign-on message using ASCII characters.
command mode signon
message binary
<string>
Sets the boot-up sign-on message using binary values.
command mode wait
time <milliseconds>
Sets boot-up wait time for serial settings.
<milliseconds> = number of milliseconds for boot-up wait time
and serial settings.
databits 7
Sets the number of EDS data bits to 7.
databits 8
Sets the number of EDS data bits to 8.
enable rs485 full-
duplex
(
EDS4100 only)
Switches the serial port to RS485 interface in full duplex
mode
enable rs485 half-
duplex
(
EDS4100 only)
Switches the serial port to RS485 interface in half duplex
mode
exit
Exits the Line menu and return to the Enable menu.
flowcontrol hardware
Sets flow control to hardware.

Lantronix EDS4100 Specifications

General

Brand	Lantronix
Model	EDS4100
Category	Server
Language	English