MPS/LPS User Guide 7: AppleTalk Configuration
7-2
AppleTalk Zones
If there is a router on the network, the MPS will appear in the
default zone specified by the router. To change the default zone
use the Define Protocol AppleTalk Zone command.
If the MPS is attached to a network without an AppleTalk router, all
AppleTalk devices (including the MPS) will appear in the default
zone in the Chooser.
Note: If no router is present on the network, the MPS will not
accept AppleTalk print jobs for 60 seconds after booting.
AppleTalk Host Troubleshooting
Table 8: AppleTalk Host Troubleshooting
Area to Check Explanation
The printer is available to be
selected in the Chooser
Make sure the printer is in the right
zone.
Bidirectional communication Lock the printer in PostScript mode
and issue the Test Service
PostScript Count n command.
This sends a job to the printer and
waits for the response.
To Next Page
Loading...
Need help?
General
