Operator's Manual
Start Up
Setting Up the Oscilloscope
Checking Shipment
Verify that all items on the materials list below have been shipped to you:
l 1 oscilloscope
l 4 passive probes (one for each channel)
l 1 AC line (power) cord rated for country of use
l 1 protective front cover
l 1 Getting Started Guide
l 1 Oscilloscope Security Certificate
l 1 Oscilloscope Registration Card
l 1 Calibration Document
Mixed-signal (-MS) model oscilloscopes also ship with:
l 1 digital leadset
l 5 flying ground leads
l 20 ground extenders
l 22 XL microgrippers
Contact your nearest Teledyne LeCroy customer service center or national distributor if anything is
missing or damaged. We can only be responsible for replacement if you contact us immediately.
Carrying and Placing the Oscilloscope
The oscilloscope’s case contains a built-in carrying handle. Lift the handle away from the oscilloscope
body, grasp firmly and lift the instrument. Always unplug the instrument from the power source before
lifting and carrying it.
Place the instrument where it will have a minimum 15 cm (6 inch) clearance from the nearest object. Be
sure there are no papers or other debris beneath the oscilloscope or blocking the cooling vents.
CAUTION. Do not place the instrument so that it is difficult to reach the power cord in case you
need to quickly disconnect from power.
922499 Rev B
3
To Next Page
Loading...
Need help?
General
