To Next Page

To Previous Page

HDO6000 High Definition Oscilloscope

6. Enter the maximum #Valuesin one bin of the histogram. This determines the number of samples that

are represented by the bar at full height.

7. Touch #Bins and enter the number of bins that comprise the histogram. This determines how many

bars appear in the histogram.

8. To let the oscilloscope determine the range of values represented by each bin/bar, check Enable Auto

Find, then touch the Find Center and Width button.

To set your own range, enter Center and Width values.

View Persistence Histogram

You can create a histogram of a persistence display, which graphs a horizontal or vertical “slice” of a

waveform.

NOTE: This math operation is different than the Histogram math operation and is not affected by Center

and Width settings made on any existing Histograms.

1. Choose Math → Math Setup... from the menu bar to access the Math dialog.

2. Touch an open Fx button and select Phistogram from the pop-up menu.

3. Touch the Fx tab to open the Function dialog, then touch Source1 and select a source trace from the

pop-up.

4. Touch the Phistogram tab at the right to open the Phistogram dialog.

5. Touch Slice Direction and select Horizontal or Vertical slice from the pop-up menu.

6. Touch Slice Center and use the pop-up keypad to enter a value.

7. Touch Slice Width and use the pop-up keypad to enter a value.

922499 Rev B

LeCroy HDO6000 User Manual

Questions and Answers: