16 of 23
To change the DRC of the M2P, select Menu > DRC, and then DRC high,
DRC low or DRC off.
Note: The M2P's DRC setting does have any effect if DRC data is not included
in the broadcast.
Station order
You can choose the order of the DAB station list to be either Alphanumeric,
Ensemble or Valid. Ensemble lists groups of stations that are broadcast
together on the same ensemble, for example BBC or South Wales local. Valid
lists valid stations first, alphanumerically, then off-air stations.
To change station order, select Menu > Station order > then Alphanumeric,
Ensemble or Valid.
7. FM radio mode
FM radio mode receives analogue radio from the FM band and displays RDS
(Radio Data System) information about the station and show (where
broadcast).
To enter FM mode, either press mode to choose FM Radio or select Menu
>Main menu >FM.
7.1 Selecting stations
To find a station, press Select. The frequency display starts to run up as M2P
scans the FM band. Alternatively, you can scan up or down by pressing and
holding the TUNE+ or TUNE- buttons or tune manually with quick presses, or
by turning the Select control.
Presets to store an FM preset, press and hold button Preset until the
display shows the Save preset screen. Select one of the 20 presets to save
the currently playing station.
To select a preset, press Preset briefly, then select one of the listed Preset
stations. When a preset station is playing, it shows ā1,2,3 etc in the bottom
middle of the screen.
7.2 Now playing information
While an FM station is playing, the screen shows one of the two following sets
data:
17 of 23
If RDS information is available, by default the service name (i.e. station
name) is displayed.
Main menu > AUX in.
3). Adjust the volume of M2P (and, if necessary, the audio source device) as
required.
9. Bluetooth mode
Prior to pairing, verify your device supports Bluetooth 4.0+EDR A2DP and
your device is not connected to any other Bluetooth product. Devices may
pair differently. Below is a general guide.
You can cycle through further RDS information by pressing Info .Each time
you press Info, another set of information is displayed, cycling through RDS
radio text, RDS programme type, frequency and today's date.
If no RDS information is available, the currently tuned frequency is shown.
7.3 Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan settings to
stop only at stations with good signal strength, select Menu > Scan setting >
Strong stations only? > Yes.
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations,
this may result in a poor signal-to-noise ratio (hiss). To play weak stations in
mono, select Menu >Audio setting > FM weak reception: Listen in mono only
> Yes.
8. AUX in mode
Aux in mode plays audio from an external source such as an MP3 player.
To play audio with Aux in mode,
1).Connect the external audio source to the Aux In 3.5 mm stereo socket.
2). Either press Source until the display shows AUX in or select Menu>
To Next Page
Loading...
Need help?
General
