17
Use the following procedure to perform a factory re-
set if the device being removed is operable.
1. Press and hold the Pairing button for ten (10)
seconds.
2. If successful a ashing green light will appear
on either device. This indicates the devices can
be paired again to a smart device network.
Use the following procedures to cycle power:
1. : To cycle power on the
sensor, remove the sensor batteries and then
reinstall them.
: To cycle power on the
wireless extender, unplug the device from the
wall outlet and then reinstall.
Occupancy Detection Feature for
Temperature Averaging
The following two features can be set using either the
thermostat or Lennox Smart Thermostat App using
the system setting screen.
From the home screen, go to Menu > > Set-
tings > .
System Settings
Back TV Room
Current Temperature
Wi-Fi
Settings
Devices
Away
TV Room
TSTAT
Battery Sensor
Light Switch
Current Temperature
Fan
Heat/Cool
Humidity
iHarmony Zoning
Notifications
Ventilation
System Info
Feels Like
Peak Monitoring
Thermostat
Off
Laura’s Room
On
TV Room
On
Off
Participating Sensors in Temperature Averaging Based on Occupancy
Figure 7. Thermostat Current Temperature Screen
To Next Page
Loading...
General