6
• Humidity Range:
» Display on thermostat: 20% to 90% RH
» Operating range: 5% - 95% RH (non-condensing)
» Sensitivity of +- 5%
IMPORTANT
The Lennox Smart Room Sensor is not a zoning
product and will not solve problems related to poor
duct work and incorrect equipment sizing.
• Extends the eective smart devices network range.
• Powered by 120VAC outlet.
• Dimension: 4" x 5.5" x 2.5" (102 x 140 x 64 mm)
• Weight: 4.24 ounces (120 grams)
Installation Considerations
If at all possible it is recommended that all Smart
Room Sensors are installed on a wall. This insures
the device will not be lost or accidentally damaged.
Consider placement when addressing the occupancy
sensor detection pattern (see page 19).
If used with the provided stand, it is recommend that
the Smart Room Sensors is placed on a bookshelf or
desk out of reach of children or pets.
Do not install the Smart Room Sensors where it can
be aected by:
• Drafts or dead spots behind doors and in corners
• Exterior entrances or interior doors
• Heat generating equipment such as kitchen
appliances
• Hot or cold air from ducts
• Radiant heat from sun or appliances
• Direct sunlight
• Concealed pipes and chimneys
• Non-conditioned areas such as an outside wall
behind the sensor
Another consideration is smart device signal strength
interference by physical objects and materials. The
type and thickness of the material can aect how
much interference is induced. One or more of the fol-
lowing can interfere with the smart device signal:
• Large metal objects and appliances like ling
cabinets, metal doors, and refrigerators.
• Floor and ceiling plenum spaces featuring joists,
plumbing, duct work, and other materials.
To Next Page
Loading...
General