Commissioning
Important controller codes
7
117
EDK82MV371 DE/EN/FR 7.0
Important controller codes
Note!
ƒ The following table describes in detail the codes mentioned in the
examples for commissioning!
ƒ Do not change codes, the meaning of which is unknown to you! All codes
are described in detail in the System Manual.
How to read the code table
Column Abbreviation Meaning
Code
Cxxxx Code Cxxxx
l The parameter value of the code can be
defined differently within each
parameter set
l The parameter value is accepted
immediately (ONLINE)
1 Subcode 1 of Cxxxx
2 Subcode 2 of Cxxxx
* Parameter value of the code is the same for all parameter sets
and can be changed in parameter set 1
Keypad E82ZBC Changed parameter of the code or subcode
will be accepted after pressing
Keypad XT
EMZ9371BC
Changed parameter of the code or subcode
will be accepted after pressing !"
#
Keypad E82ZBC Changed parameter of the code or subcode
will be accepted after pressing if the
controller is inhibited
Keypad XT
EMZ9371BC
Changed parameter of the code or subcode
will be accepted after pressing !" if
the controller is inhibited
(A) Code, subcode or selection only available for operation with
application I/O
uSEr
Code is contained in the Lenze setting in the USER menu
Designation Name of the code
Lenze Lenze setting (value at delivery or after restoring the delivery
status with C0002)
à
Further information can be obtained from the "IMPORTANT"
column
Selection 1 {%} 99 Min. value {unit} max. value
IMPORTANT − Brief, important explanations
To Next Page
Loading...
Need help?
General