Safety instructions
Application as directed
2
10
Lenze ¯ BA 33.0005 ¯ 5.0
Electrical installation
¯ Carry out the electrical installation according to the relevant regulations (e. g.
cable cross−sections, fusing, connection to the PE conductor). Additional notes are
included in the documentation.
¯ Only plug in or remove pluggable terminals in the deenergised state!
Commissioning
¯ If required, you have to equip the system with additional monitoring and
protective devices in accordance with the respective valid safety regulations (e. g.
law on technical equipment, regulations for the prevention of accidents).
¯ Before commissioning remove transport locking devices and keep them for later
transports.
2.2 Application as directed
Low−voltage machines are not household appliances but are intended as components
that are only applied for re−use for industrial or professional purposes in terms of
IEC/EN 61000−3−2. They comply with the requirements of the Low−Voltage Directive
and the harmonised standards of the IEC/EN 60034 series.
Low−voltage machines must only be operated under the operating conditions and
power limits specified in this documentation.
The integrated brakes must not be used as safety brakes. It cannot be ruled out that
interference factors which cannot be influenced cause a brake torque reduction.
Low−voltage machines with IP23 protection or less are only intended for outdoor use
when applying special protective features.
Products included in the scope of application of the EU regulations (EG) 640/2009
and (EU) 4/2014 (and hence ErP Directive 2009/125/EG) and which did not comply
with minimum efficiency requirements when first put into circulation, are not CE
compliant and will not receive CE marking. The product is for exclusive use outside
the European Economic Area (EEA) only.
Motors of efficiency class IE2 with a rated power of 7.5 kW ... 375 kW which are
included in the scope of application of the EU regulations (EG) 640/2009 and (EU)
4/2014 and which were put into circulation in the European Economic Area (EEA)
after 31 December 2014 may be exclusively used there on a frequency inverter for
speed control only. These motors receive the following additional marking.
IE 2
EU REGULATION 640/2009
USE WITH VARIABLE
SPEED DRIVE ONLY!
Any other use shall be deemed inappropriate!
To Next Page
Loading...
Need help?
General
