42
PROGRAMMING MODE
14. Thermistor control temperature Setup
Thermistor control temperature Setup
Display
Enter SVC Mode
Press 1st button
Press 2nd button
Press Start button
Press 2nd button or 3rd button Until display shows
Press Start button
Select the Temperature you want
Button functions :
Start button = Select
1st button = Go back a step
2nd button = Move up or Increase value
3rd button = Move down or Decrease value
Press Start to set the temperature The next course setting will be displayed.
• Range : 60~68
• Increments : 1
• COS1 : High Temp
• COS2 : Med Temp
• COS3 : Low Temp (COS3 is not available in tEPt)
• COS4 : No Heat (COS4 is not available in tEPt)
NOTE
To Next Page
Loading...
Need help?
General
