50
PROGRAMMING MODE
Programming Mode – Test Mode
Diagnostic tests : (display)
This program has been added for testing the dryer and detecting errors.
1. Test
Test features can be used to check and change various machine settings.
Test
Display
Enter SVC Mode
Select the feature you want
Button functions :
Start button = Select
1st button = Go back a step
2nd button = Move up
3rd button = Move down
• : Factory Use (Do not Use)
• : Diagnostic Test 1
• : Factory Use (Do not Use)
• : Factory Use (Do not Use)
• : Factory Reset
• : Time Setting
• : Courtesy Cycle
• : Kill cycle
• : Duct check
• : Password Setup
NOTE
How to enter Programming mode:
- Coin type – Turn on/off the toggle switch.
- Card type – Insert the service card.
- All types –
1) Press the 1st & 3rd button at the same time.
2) Press the 2nd & 3rd buttons to toggle numbers.
Then, press the 4th button to move to the next digit.
3) Press the Start button to finish password input.
※ Default Password : 3000
<Control Panel >
1st
2nd
3rd
4th
Start
To Next Page
Loading...
Need help?
General
