Version 1.0 Page 14 / 43
2. Press and release the active green lighting source button. The output is
muted.
Info Deselected destinations are disconnected from any source, thus output devices
will display black image or "no signal" message or automatically will turn off.
SAVE or LOAD PRESETS
MX4x4DVI and MX4x4DVI-DL has 4 front panel programmable presets. Each
preset stores a configuration regarding all input connections for all outputs. All
presets are stored in a non volatile memory, the router keeps presets even in case
of power down. Memory numbers are assigned to source buttons 1 to 4
Saving a Preset in TAKE mode
1. Press and release SAVE PRESET button.
2. Press and release the desired source (memory address) button (source 1 to
4)
3. Press and release TAKE button. Now the current configuration is stored in
selected memory.
Info Preset save action always stores the current configuration for all outputs
Loading a Preset in TAKE mode
1. Press and release LOAD PRESET button.
2. Press and release the desired source (memory address) button (source 1 to
4)
3. Press and release TAKE button. Now the selected preset is loaded.
Info Loading a preset always modifies all output states.
Saving a Preset in AUTOTAKE mode
1. Press and release SAVE PRESET button.
2. Press and release the desired source (memory address) button (source 1 to
4). Now the current configuration is stored in the selected memory.
Info Preset save action always stores the current configuration for all outputs .
To Next Page
Loading...
Need help?
General
