2.2 Conditions of Use
The bed may not be used and stored in indoor environments:
Where there is a risk of explosion.
Containing inflammable anaesthetics.
The bed is designed for use in rooms for medical purposes. Electrical installations must therefore meet local stan-
dards laying down the necessary conditions for electrical installations.
Disconnect the bed from the mains in exceptional cases (i.e. a storm).
2.3 Specifications of Use
Medical purpose:
Hospital bed for acute care, support for patient in various positions (Horizonal position, Trendelenburg,
cardiac chair, etc.)
Patient:
For patiens older than 15 years. Weight of patient + mattress + accesories can not be higher than safe
working load (SWL). Condition of patient is not important.
Personnel:
Qualified medical staff (nurse, doctor) with medical school or university (EU). Any person familiar with the
manual. Patient if the condition permits.
Location:
The bed is determined for application environments 1, 2, 3 and 5 according to EN 60601-2-52:2010. The
stable undercarriage with 4 castors makes it possible for the bed to be handled by one person. However,
the manufacturer recommends that at least two persons handle the bed.
3 Standards and Regulations
The bed complies with the following standards and directives:
IEC 60601-1:2012
IEC 60601-1-2:2007 3.ED
IEC 60601-1-6:2010
IEC 60601-2-52:2010
ISO 15223-1:2012
ISO 10993-5:2009
ISO 10993-10:2010
93/42/EEC
2011/65/EU
The manufacturer adheres to a certified quality management system in compliance with the following
standards:
ISO 9001:2008
ISO 14001:2004
EN ISO 13485:2003
To Next Page
Loading...
Need help?
General
