36
Clock Setting
When the microwave is connected to the mains power, the LED display will show ”0:00” and the microwave
will sound once. Please ensure that you have set the clock prior to use.
Please follow the steps below to set the clock.
1. Press the
button, the hour digits will ash. The unit
will also beep.
2. Press the
/ buttons to adjust the hour digits. The
input time has to be within 0-23.
3. Press the
button, the minute digits will ash. The
unit will also beep.
4. Press the
/ buttons to adjust the minute digits.
The input time should be within 0-59.
5. Press the
button to nish clock setting. The unit will
also beep.
“:” will start ashing and the time will illuminate.
1, 3, 5
2, 4,
• This is a 24-hour clock. When the microwave
is connected to the mains power for the rst
time or when the power is resumed after a
power interruption, the LED display will show
“0:00”. To re-set the clock, simply follow the
above 5 steps.
• In the process of clock setting, if the
button
is pressed or if there is no operation within 5
minutes, the microwave will go back to the
previous status automatically.
• If the clock needs to be reset, please repeat
steps 1 to 5.
• To nd out the current time while the
microwave is operating, press the
button.
It will last for 3 seconds and then return to its
original display.
L23CB_W_S13E_5L_140528_grace.indb 36 28/5/14 5:47 pm
To Next Page
Loading...
Need help?
General
