21
3 Testing your remote after you have set up your RF System
Your remote will walk you through steps to test your system after you have set up your RF System.
If your Blasters aren’t placed properly or you have not assigned your devices correctly,
your remote’s screen will walk you through steps to correct any issues you may be
having.
Test and test again
Before you being the test, make sure all of your devices are off.
If you have closed cabinet, you should also perform this test with the doors closed.
2 Assigning your devices
You can control your devices with either your Harmony remote or your RF System. Typically, you use
the Harmony remote to control devices with which you have a clear line-of-sight, and you use the RF
System to control devices that are in a closed cabinet or that span different rooms.
For example, you would likely use your Harmony remote to control the TV because it is out in the
open, but you would use your RF System to control the AV receiver and the DVD player, which are
tucked away inside a cabinet.
During initial set up, your remote will walk you through the steps to assign devices to your Harmony
remote or RF System.
Device Assignment
1/2 pages 7:15
Select devices you want to
be controlled by your RF
system
Cancel Done
e
To Next Page
Loading...
Need help?
General
