5-9. Every 600 hour check
(1) Changing Front axle oil
Remove left/right drain plug and oil filling inlet to
drain oil completely.
Wrap the sealing tape on the plug and tighten
the drain plug.
Add new oil into the oil filling inlet with checking
if the oil flows out through the oil check port.
After 5~10 minutes later, check the oil level
again and tighten all the plugs.
Oil capacity : 8 L (2.1 U.S.gals.)
Drain plug
Oil filling inlet
Oil filling inlet
(2) Changing Transmission oil
Stop tractor on a level surface and apply parking
brake. Run engine for several minutes to warm oil
and lower implements and stop the engine.
Set container under the drain plug and remove
drain plug under the transmission and drain oil
completely.
tighten drain plug again with cooper washer.
Add new oil until the oil level is between “Min” and
“Max” of the oil gauge.
Oil capacity : 43 L (11.4 U.S.gals.)
▶
The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling inlet and then open the cap.
Caution
To Next Page
Loading...
Need help?
General
