MAAX Coleman Spas 400 Series User Manual

20
Error messages on the LCD display
Error messages on the LCD display
The most common error messages, their likely causes and solutions, are described in the following table:
The LCD-
display
shows...
OHH
OHS
HFL
LF
This means...
Overheating - one of
the sensors has detected
a water temperature of
more than 47.5 °C in
the heater
Overheating - one of
the sensors has detected
a water temperature of
more than 43 °C in the
heater
Problem with the water
flow to the heater
Problem with the
water flow - stubborn
problem
What happens...
The heater is
automatically
switched off until
the temperature
falls below 43 °C
The heater is
automatically
switched off until
the temperature
falls below 43 °C
Heater is switched
off while the spa
continues to
operate normally
Heater is switched
off while the spa
continues to
operate normally
Possible cause...
•Low-speed
pump running
for too long
•Programming
error causes
continuous
filtration
•Low-speed pump
running for
too long
•Programming error
causes continuous
filtration
•Blocked filter
•Low water level
•Blocked filter
•Low water level
Solution...
• Check whether the sliding
valves are open
•Re-program so that cycles
do not overlap each other
• Contact your supplier is
the problem persists
• Check whether the sliding
valves are open
•Re-program so that cycles
do not overlap each other
• Contact your supplier is
the problem persists
•Remove and clean filter
•Add water
• Contact your supplier or
maintenance engineer
•Remove and clean filter
•Add water
• Contact your supplier
or maintenance engineer

MAAX Coleman Spas 400 Series Specifications

General

Brand	MAAX
Model	Coleman Spas 400 Series
Category	Hot Tub
Language	English