MAAX Coleman Spas 400 Series User Manual

11
Operating systems
Starting procedures
1. Fill the spa with tap water via the filter
opening up to the mark on the skimmer.
Never use softened water in your spa.
Softened water can affect the chemical
balance of the spa water and result in
damage to metal components.
2. Connect the spa to the electricity supply.
3. Open the Air Controls, which are on the
top edge of the spa and rotate the jets
downwards. You will now hear water coming
out of the therapeutic jets. If this does not
happen, turn off the jets and follow the text:
‘Starting to use your spa’.
4. Add the chemicals. Refer to the section
on the maintenance of water quality.
5. Follow the user instructions for your
own model for setting the desired water
temperature. Initially, it may take 12 to
14 hours before the spa has fully warmed up.
To assist the heating process, leave the
heat cover on the system and close the
Air Controls.
Important: do not use the spa if the water does
not come powerfully out of the jets.
Starting to use your spa
When you fill the spa for the first time, or after
you have emptied and refilled the spa, you may
have to get the air out of the system. If you
suspect there is an airlock in the system, remove
the filter basket, push a garden hose as far as
possible through the filter opening without
applying force. Hold the hose in place and
open the tap. This will force water into the
pump and air out of the pump.
Operating systems
Powerworks™ operating system 630/736 series
(430/432 series)
The 630/736 series Powerworks™ operating
system is the best operating system for your spa.
The backlit LCD display shows the actual water
temperature, the set water temperature, the time
and the user settings. Each system function is
activated using a press button on the operating
panel. To activate the chosen function, just press
on the respective button.
When starting up, if the spa is connected to
the electricity supply, the operation should
function correctly and safely according to
the factory settings. The spa will then be in
Standard mode, the temperature is set to
37.5 °C and a filter cycle of three hours is
selected.
NOTE:
In the event of a loss or interruption of
the power supply, all settings of the 630/736
series operating system should be stored.
However, if individual settings are lost, you
can reprogram them using the instructions
in this manual, or by calling your supplier.

MAAX Coleman Spas 400 Series Specifications

General

Brand	MAAX
Model	Coleman Spas 400 Series
Category	Hot Tub
Language	English