MAAX Coleman Spas 400 Series User Manual

17
Filter cycles
Press on UP or DOWN to set the duration of
the cycle. Each time you press the button, the
cycle duration is show on the LCD display as
follows:
FIL1 1 hour per cycle, 2 hours per day
FIL2 2 hours per cycle, 4 hours per day
FIL3 3 hours per cycle, 6 hours per day
FIL4 4 hours per cycle, 8 hours per day
FIL5 5 hours per cycle, 10 hours per day
FIL6 6 hours per cycle, 12 hours per day
FIL7 7 hours per cycle, 14 hours per day
FIL8 8 hours per cycle, 16 hours per day
FIL9 9 hours per cycle, 18 hours per day
FILA 10 hours per cycle, 20 hours per day
FILB 11 hours per cycle, 22 hours per day
FILC 12 hours per cycle, 24 hours per day
To finish setting the filter cycles, press JETS 1.
You will now see the current water temperature
or stripes on the LCD display.
If you change the duration of a filter cycle while
it is in operation, the change is immediately
carried out. Otherwise, the change is effective
at the start of the following filter cycle.
To change the start times of the daily filter cycles,
turn off the power supply and then turn it on
again when you want the first cycle to start.
NOTE:
If there is no power supply to the spa
(disconnected, or power cut), the settings may
reset to the standard factory settings. You will
then have to reprogram any changes you have
made to the temperature or the filter cycle
duration.
Cleaning cycle
After periods of intensive use, set the jets to
Low whirlpool for a cleaning cycle of four hours.
Tu rning the LCD display round (630/736 series)
The 630/736 series operating system has a function
that allows the LCD display to be ‘turned round’
so that it can be read from inside or outside the
spa. To rotate the LCD display, press the Invert
button. To rotate the LCD display again, press
the Invert button again.
The extra operating panel (736 series)
The extra panel gives you the option of
operating the jets and the lights without leaving
the Full-Body Massage Seat. The three buttons
for the jets work in the same way: press once to
set the jets at low speed, press twice to set them
at high speed, and three times to switch the jets
off.
Turbo Air Booster option (630 series)
Depending on your type of spa, your model
may be fitted with a Turbo air system to
increase the power and therapeutic effect
of the jets. To switch the Turbo Air System
on and off, press the AIR MASSAGE button.
NOTE:
The Turbo Air blower automatically switches
off after 30 minutes.
At the start of a filter cycle, the blower is acti-
vated to clean the water in the pipes and to
guarantee complete filtration. Make sure that
at least one Air Control is fully open.
Selecting different lighting options
(fibre optics system)
The standard DOL setting is Mode 1 (see
below). To change the mode, press the Light
or Fibre Optic button off and on within five
seconds. The lighting changes to the following
colour-coded mode. Go through them and
select your chosen colour.

MAAX Coleman Spas 400 Series Specifications

General

Brand	MAAX
Model	Coleman Spas 400 Series
Category	Hot Tub
Language	English