MAAX Coleman Spas 400 Series User Manual

15
Standard/Economy/Sleep modes
Standard/Economy/Sleep modes
You can switch between Standard, Economy
and Sleep modes by pressing the MODE/PROG
button (430/432 series: MODE). If you place
the spa in Standard mode, the low speed of
pump 1 and the heating are automatically set
to keep the water at the set temperature. If you
set your spa in Economy mode, the heater
ONLY works during the filter cycles. In this case,
pump 1 activates several times per day for about
two minutes to check the water temperature.
If you place the spa in Sleep mode, the heater
and the pump only operate during the filter
cycles to keep the water 6.5 °C below the set
temperature.
The selected mode is show in the LCD display
on the operating panel. In standard mode,
STANDARD is displayed (430 series: STD).
In economy mode, ECONOMY is displayed
(430 series: ECN). If Sleep mode is selected,
nothing is displayed (430 series: SLP is shown).
Setting the time and filter cycles
This function is designed so that by connecting
the spa to a properly earthed supply and pressing
the MODE/PROG button (430 series: MODE),
the spa functions properly and safely at 37.5 °C.
In this mode, all user buttons are active.
However, to be able to benefit from the unique
possibilities of this function, it is important to
set the time and filter cycles.
Setting the time (630/736 series only)
When the spa is connected to the power supply,
the message SET TIME appears on the LCD
display. Press TIME and then MODE/PROG.
Then press SET UP to move the time forward,
or SET DOWN to move the time backward.
Press one of the buttons again to finish setting
the time. Press MODE/PROG to store the time
and to finish the time setting procedure.
The water temperature is now shown on the
display.
Advance setting of filter cycles (630/736 series)
Now the time is set, the spa will automatically
filter the water for three hours every 12 hours.
Whenever an automatic filter cycle is being
carried out, this procedure is shown on the
LCD display as Filter 1 or Filter 2.
Filter 1
The first filter cycle is automatically activated at
02.00 hours. The filter cycle using the low-speed
pump is carried out at 05.00 hours. During this
cycle, the heater works in Economy mode.
Filter 2
The second filter cycle is automatically activated
at 14.00 hours and runs until 17.00 hours
using the low-speed pump. The heater also
works in Economy mode during this cycle.
The second pump and blower also go through
a brief cleaning process during this cycle.
NOTE:
To keep the spa clean, a total filter time of at
least six hours per day is recommended.
Changing the filter cycles (630/736 series)
If you want, you can adjust the start and stop
times as well as the duration of each filter cycle.
The time required to filter your spa depends
on the level of use and the condition of the
surroundings. Use the following procedure if you
prefer a different filter time or duration, or if
you want to leave the heater off during filtering.
Press the TIME button. The central display
shows the time. Press on MODE/PROG
and the set time is displayed. Press again on

MAAX Coleman Spas 400 Series Specifications

General

Brand	MAAX
Model	Coleman Spas 400 Series
Category	Hot Tub
Language	English