Maintenance Manual MAN-00135
GENIO DC (BS-III & BS-IV)
JULY 2011/Rev1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes
introduced by the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or
whole of the present document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the
Authorized Service Centre of Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution © 2011 Mahindra & Mahindra Ltd.
705-MAT-0001 : 0.30 hrs.
ENGINE OIL – REPLACE
Engine oil – MAXIMILE CROWN (SAE 15W-40) API CH4
Capacity – 6.0 Lit.
Park the vehicle on level ground/2 post lift* /4 post lift
If the activity is done on a 2 post lift, ensure that the LSPV spring is disconnected
before lifting the vehicle. After lowering, re-connect the LSPV spring and ensure
that the setting height is correct.
Engine should be hot while draining the oil.
For other than Maximile brand, the oil change interval has to be reduced to
10000kms if the oil meets minimum of API CH-4 SAE 15W-40 specification.
Recommended intervals for Maximile CROWN engine Oil change are at 5000,
20000kms & then at every 20000kms.
Nut/ Bolt description Quantity Nos. Spanner Size Torque Value – Nm.
Oil Sump drain plug 01 22 mm 27.5 ± 2.5
Oil Drain & Refill –
1. Open the oil filler cap.
2. Put the oil collecting tray below the sump, loosen & remove the oil sump drain plug.
Allow the oil to drain for 15 min.
3. Fit the drain plug with a new gasket/ washer. Torque tightens the Drain Plug –Torque -
27.5 ± 2.5 Nm.
4. Fill fresh oil as per the recommended quantity and specification.
5. Refit the oil filer cap & check the oil level as per procedure 910-MAT-0002.
Oil Filler Cap