17
Auxiliary fence
Make auxiliary fence from 9.5 mm and 19 mm plywood pieces.
Wood facing (rip fence)
A wood facing should be used for operations when the blade comes close to
the rip fence. Wood facing for the rip fence should be the same size as the rip
fence. Make sure the bottom of facing is flush with the table surface.
Ripping
CAUTION:
• When ripping, remove the miter gauge from the table.
• When cutting long or large workpieces, always provide adequate support
behind the table. DO NOT allow a long board to move or shift on the
table. This will cause the blade to bind and increase the possibility of
kickback and personal injury. The support should be at the same height
as the table.
1. Adjust the depth of cut a bit higher than the thickness of the workpiece.
2. Position the rip fence to the desired width of rip and lock in place by piv-
oting the grip. Before ripping, make sure the rear end of the rip fence is
secured firmly. If it is not secured enough, follow the procedures in the
section titled “Installing and adjusting rip fence”.
3. Turn the tool on and gently feed the workpiece into the blade along with
the rip fence.
(1) When the width of rip is 150 mm and wider, carefully use your right
hand to feed the workpiece. Use your left hand to hold the work-
piece in position against the rip fence.
9.5mm
19mm
120mm
40mm
140mm
460mm
1
006210
1. No. 10 wood screws (long enough
to penetrate halfway into facing)
1
006165
006169
006172
To Next Page
Loading...
Need help?
General
Weight and Dimensions
