Makita 2704 User Manual

18
(2) When the width of rip is 65 mm - 150 mm wide, use the push stick
to feed the workpiece.
(3) When the width of rip is narrower than 65 mm, the push stick can-
not be used because the push stick will strike the blade guard. Use
the auxiliary fence and push block. Attach the auxiliary fence to the
rip fence with two “C” clamps.
Feed the workpiece by hand until the end is about 25 mm from the
front edge of the table. Continue to feed using the push block on
the top of the auxiliary fence until the cut is complete.
Cross cutting
CAUTION:
• When making a crosscut, remove the rip fence from the table.
• When cutting long or large workpieces, always provide adequate support
to the sides of the table. The support should be at the same height as the
table.
• Always keep hands away from path of blade.
1. Push stick
1
006171
1. Auxiliary fence
1
006170
1. Push block
2. Auxiliary fence
1
2
006220

Makita 2704 Specifications

General

Input power	- W
Blade bore	15 mm
Blade diameter	255 mm
Saw blade included	-
Idle speed (max)	4800 RPM
Cutting depth (45º)	63 mm
Cutting depth (90º)	91 mm
Product color	Blue, Stainless steel
Placement supported	Tabletop

Weight and Dimensions

Depth	665 mm
Width	753 mm
Height	344 mm
Weight	28000 g
Bore diameter	15.88 mm