Commissioning and operation
33
3. MMDS-CLC 6.5 display device (colour display)
Introduction
This document describes how the MMDS-CMS 6.5 colour display with MMDS-CLCB 6.5 remote control op
erates and is used in its application as an engine display to monitor engine operation. Fitting, mounting and
installation are explained in separate instructions for the unit.
The engine and gearbox data are shown on the colour display in the form of dials and digital displays.
LED symbols are used to display alarms; these are complemented by a table which lists all alarms present
with more detailed information.
A logo which will be displayed on all pages may be activated when installed. The shipyard can select this
logo selection itself (see page 47).
Function
The colour display is automatically activated when the supply voltage is applied. It can then be switched on
and off manually using the “Power" button . The other alarm functions such as the alarm relay
and the internal buzzer and the acknowledge button remain operative.
The engine speed display incorporates a damping algorithm to simulate mechanical instruments.
This means that small variations do not lead to an unstable display, which could irritate the officer con
trolling the ship.
To Next Page
Loading...
Need help?
General
