Remove top panel first.
Unfasten three M5.5 hex head flange bolts at the back panel of
the appliance attaching the top panel to the back panel.
Slide the top panel towards the back of the appliance and remove
it.
2.
Removing the side panels:
Unfasten six M5.5 hex head flange bolts (three per side) at the
back panel of the appliance attaching each side panel to the back
panel.
Slide the left and/or right side panel towards the back of the
appliance and remove it/them.
3.
Removing the back panel:
Unfasten four M5.5 hex head flange bolts attaching the back
panel to the cooling duct (two bolts) and bottom panel (two bolts)
of the appliance.
Move the back panel up and remove it.
To Next Page
Loading...
Need help?
General