Top section (picture on the left):
The QTS (Quick Touch Screen) board lies behind the
easyToUCH screen and is attached to the front panel of the oven.
Bottom section (picture on the left):
The much larger SRB (System Relay Board) extends over the
whole width of the oven and rests in a tilted position close to the
front panel of the oven. It is mounted to the frame of the casing.
Tools required
M5.5 hex socket wrench
Requirements
Check that the following requirements have been met:
The appliance has been disconnected from the power supply and protective measures have been
taken to ensure the power cannot be switched on again.
The appliance is cool.
The top and side panels of the casing of the appliance have been removed.
The high voltage capacitors are discharged before commencing work.
Anti-static precautions have been taken.
To Next Page
Loading...
Need help?
General