The touchscreen overlay can be removed without removing the
side or back panels of the casing. There is an access hole for a
locking screw underneath the front panel.
Release the screw using a M5.5 hex socket wrench.
2.
Slide the touchscreen element to the left and detach it from the
frame of the casing.
NOTICE:
Mind the cables attached to the QTS assembly.
Fitting the touchscreen overlay
Follow the steps in the reverse order to fit the touchscreen overlay.
NOTICE:
If the electric connections have not been restored properly this may lead to malfunction/damage of the
oven.
To Next Page
Loading...
Need help?
General