Manitowoc Published 08-06-19, Control # 237-09_v2 4-47
MLC165-1 OPERATOR MANUAL SETUP AND INSTALLATION
Connect Electric Cables from Crane to
Boom Butt
See Figure 4-40.
1. Stop the engine.
2. Disconnect the dust caps from the receptacles and
electric cable connectors.
3. Thoroughly clean all electric connectors.
4. Disconnect CAN terminator (1, View A) from the WBC
cable (2) on the right side of the rotating bed.
5. Connect the WBC cable (2) from the crane to the WBC
cable on the cable reel in the boom butt.
6. If equipped with the position light option, connect the
WWLA cable from the cable reel in the boom butt to the
receptacle (3, View A) on the right side of the rotating
bed.
7. If equipped with the optional drum in the boom butt,
connect the W44 cable from the drum to the receptacle
(4) on the right side of the rotating bed.
8. If equipped with the drum camera in the boom butt,
connect the electric cable from the camera to the
receptacle (5, View B) in the left front enclosure.
9. If equipped with boom work lights, connect the electric
cable (6, View C) coiled on the front of the rotating bed to
the receptacle on the electric cable (7) at the end of the
adjacent boom section.
Coiled on front of rotating bed or on
engine node in right side enclosure.
Figure 4-40
View A
Item Description
1 CAN Terminator
2 WBC Cable (from engine node)
3 Receptacle for Optional Position Light
4 Receptacle for Optional Drum in Boom Butt
5 Receptacle for Boom Butt Camera
6 Boom Work Lights Electric Cable from Crane
7Receptacle
View B
View C
Left Side of Boom Butt
Front of Left Enclosure
Right-Front Side of Rotating Bed
To Next Page
Loading...
Need help?
General
