2017 OWNERS MANUAL / 116
If you select Yes (by pressing the second button on the right side),
the following screen will appear. First screen that appears when you
select Fuel Settings:
Procedure To Enter Added Fuel
Step Action
1 If the blue highlighting (shown above on the Full line) is not
surrounding the box that contains 0.0 gal, utilize the up
arrow by pressing the third button on the right side until
0.0 gal is highlighted.
2 Press the second button on the right (Select).
3 The cursor will position under the first 0, and yellow high-
lighting will surround the number 1. Utilize the up arrow
(third button) until the yellow highlighting surrounds the
appropriate first digit of the amount of fuel added.
4 Press Select (second button on the right). The cursor then
moves to the second digit.
Step Action
5 Utilize the up arrow once again (third button) until the
yellow highlighting surrounds the appropriate second digit
of the amount of fuel added.
6 Press Select (second button). Once all four digits have
been entered, the blue highlighting will automatically go to
Save. Press Select again.
7 Press Back to exit Fuel Settings (fourth button on the left
side).
NOTE: If the amount of fuel added has filled the tank, simply
choose Full and select Save. If the amount of fuel added plus
the existing fuel is greater than the tank capacity, the display
automatically reverts to Full. To subtract fuel enter the correct
amount to subtract, and touch the +/- button
User Settings
The User Settings option provides the user a way to specify viewing
preferences. The settings are all editable by using the soft keys to
the right of the option. There are two user settings screens.
MAIN SETTINGS MENU
The Main Menu screen for viewing engine statistics can be
accessed by pressing the fourth Quick Access Key on the left side
of the HV450. The following settings are available:
Fuel Settings
Enter the amount of fuel added to assist in proper fuel
management.
User Settings
Customize the display options for ambient light and brightness,
set US or metric units and other settings.
Service Information
Provides information about the software version, dealer, oil
changes and dealer services.
Engine Diagnostics
Displays a list of engine fault codes and descriptions; on some
engines, corrective action will be shown.
PDM Diagnostics
Displays power distribution module information (short circuit,
over-current, open circuit and no fault) for various electrical
input and output components of the craft.
Factory Settings
Displays settings for boat model, center tab, surf tabs, depth/
water temperature, dealer and stereo. NOTE: These settings
require a dealer code to access them.
NOTE: Some settings require a dealer code for access.
Fuel Settings
When power is first applied to the unit, the following screen appears:
To Next Page
Loading...
Need help?
General
