2017 OWNERS MANUAL / 226
• If a fire begins in another location other than the engine compart-
ment, remove the fire extinguishers from their storage location,
• Activate them as indicated above and attempt to put out the fire.
Remain alert to the fact that a fire near or in the fuel tank or fuel
lines is especially dangerous. Follow the instructions in the pre-
ceding paragraph, if a fuel fire begins or if the fire extinguisher(s)
has not been eective in putting out the fire.
CLEATS
Models
All
Purpose
Cleats are an important feature of MasterCraft boats. The cleats
allow boaters to tie-up to docks with ease and confidence.
Following the activation of the automatic fire suppression system
or a hand-held fire extinguisher, a careful determination should be
made as to whether the boat can safely be operated. If there is any
doubt or concern whatsoever, the boat should be towed to shore
and/or dock for service by an authorized MasterCraft dealer prior
to operating again. Failure to follow these instructions could result
in death or serious injury/illness.
Troubleshooting
• If there is evidence of fire in the engine compartment of a V-drive
boat and the automatic fire suppression system does not acti-
vate, pull the manual override (on domestic boats only). The over-
ride location is illustrated in the Guide to Individual Models of this
Owner’s Manual. Boat owners should also confirm this location
with the assistance of an authorized MasterCraft dealer.
• If the manual override does not deploy, ensure all persons on-
board are equipped with PFDs (personal flotation devices). If
there is time, send visual and sound signals of the emergency. All
persons should abandon ship and move to a safer location. Boats
can be consumed by fire and even explode if there are fuel fumes.
Location
Automatic Fire Extinguishers: All automatic fire extinguishers are
located in the engine compartments on all boats. The locations of
automatic fire suppression override units’ manual override varies by
model, but generally is in the vicinity of the helm.
Manual Fire Extinguishers: Manual fire extinguishers have various
locations within the boat, but are generally located under either the
observer seat or in the head and all are easily accessible. Be certain
to determine the location of all fire suppression and extinguishing
units on the boat. Your authorized MasterCraft dealer can assist you.
Operation
Automatic Fire Extinguisher Manual Override: It is possible to man-
ually override the HFC-227 fire extinguishing system on all non-CE
packaged boats. Pull the pin from the red handle labeled FIRE near
the helm seat. Pull up on the FIRE handle to deploy the system.
Manual Fire Extinguishers: Pull the pin and squeeze the trigger.
Special Attention
In case of an engine compartment fire, shut down the engine and
blowers before manual discharge, or immediately following the
automatic discharge. Boats are equipped with a discharge indica-
tion light at the instrument panel or on the video display gauge at
the helm.
Location
Cleat locations vary by model. (See Guide to Individual Models in
this Owner’s Manual to determine the locations for your model).
Cleats will be on top deck sides of the bow, and aft near the tran-
som. Some larger models also have mid-ship cleats. Some cleats
are elevated slightly above the deck while others are pop-up cleats
that fit flush with the deck when not in use.
Operation
Use marine-grade lines to loop over the cleat and tie up to the dock,
allowing some slack in the rope. If there is any motion in the body of
water, MasterCraft recommends also purchasing “fenders” from an
aftermarket supplier to provide a cushion between the boat and the
dock. Without a cushion, the boat’s finished gel coat and graphics
can be damaged. Such damage is not covered under warranty.
The boat should be tied to docks with marine-grade lines ONLY
to the cleats, and allowing some slack. Never tie-up the boat to
the tower, mirror, seats or any other part of the boat. If the ability
exists to tie up to all cleats on the side nearest to the dock, opera-
tors should do so. MasterCraft also recommends using fenders to
cushion the side of the boat in the event of water motion. Other-
wise, the boat gel coat and graphics may be damaged, and such
damage is not covered under the warranty.
To Next Page
Loading...
Need help?
General
