2017 OWNERS MANUAL / 352
the growth of mildew. Mold and mildew need something on which
to grow and polyester fabric is not a desirable substance for such
growth. Dirt or dust on the fabric, however, is a perfect source for
mildew growth, which makes regular cleaning of the fabric important.
The material has an applied finish that deters mold and mildew
growth, but it does not make it mold-proof. Keeping the fabric free of
dirt and foreign substances is important in deterring mold growth.
There is no set time for when the fabric should be cleaned, and the
local environment has a great deal to do with determining cleaning
frequency. Cleaning is required less frequently in a dry environment
than in a humid one where heavy foliage exists.
Cleaning
One of the best ways to keep the material looking fresh and new,
and to delay the need for deep or vigorous cleaning, is to hose o
fabrics with clear water on at least a monthly basis with clear water.
This practice will help prevent dirt from becoming deeply embedded
in the fabric, and it will eliminate the need for more frequent and
more vigorous cleanings.
In most environments, a thorough cleaning will be needed approxi-
mately every two (2) years.
The fabric can be cleaned while still in the boat. When cleaning, it is
important to observe the following:
• Always use a natural soap—never detergent.
• Water should be cold to lukewarm, but never more than 100
degrees.
• Air dry only. Never apply heat to the fabric.
• Begin by brushing o loose dirt, and then hose down the material.
Prepare a cleaning mixture of water and a mild, natural soap that
is free of detergents. Use a soft-bristle brush to clean, allowing the
soap to soak in. Rinse thoroughly and allow the fabric to thoroughly
air dry.
If stubborn stains persist, you can use a diluted chlorine bleach/
soap mixture for spot cleaning of mildew, roof run-o and other sim-
ilar stains. Please keep in mind that chlorine bleach will not change
the color of the fabric, but chlorine bleach will eventually break down
the fiber of any fabric. Therefore, this cleaning method should be
used as infrequently as possible.
The cleaning mixture should be mixed as follows:
• Four ounces (one- half cup) of chlorine bleach.
• One gallon of water.
Clean with a soft- bristle brush and allow the mixture to soak no
longer than twenty (20) minutes. Rinse thoroughly and allow to
completely air dry. Repeat if necessary.
CANVAS COVERS
The material used in constructing bimini tops and boat covers
is made from 100 percent solution-dyed polyester fiber with a
urethane coating to provide excellent water repellency and mildew
resistance. This design allows the material to be easily maintained.
By following a few simple care and cleaning steps, the fabric will
continue to look good and maintain its fine qualities for seasons to
come.
Important Background Information
Because the fabrics are woven, they are breathable. It’s also im-
portant to know that these fabrics are treated with a fluorocarbon
finish, which enhances water repellency. This finish requires replen-
ishment after vigorous cleaning. Polyester fabric will not support
Fiberglass Swim Platform
The fiberglass swim platform requires the same kind of regular—
and gentle—cleaning that the rest of the boat needs. After cleaning
o any environmental debris, wash with mild soap and warm water.
Avoid the use of ArmorAll or similar types of rubber-shine products
as these will speed the decay of the rubber rather than protect it.
WINDSHIELD
In cleaning tempered glass windshields, the normal glass cleaners
(from spray bottles or aerosol cans) work best. While the glass is
very strong, it can be scratched if anything abrasive is used. Harsh
chemicals or solvents should be avoided because they may aect
the vinyl gaskets, anodized or powder-coated finish on the extrusions.
To Next Page
Loading...
Need help?
General
