MasterCraft NXT22 2017 User Manual

2017 OWNERS MANUAL / 278
HEATER
Models
All models, as an option.
Purpose
Warmed air from an electrically powered heater box will be blown
from vents within the boat deck, to keep occupants warm.
Location
Heater vent locations vary by model, but all are located within the
cockpit. They typically reside in the driver’s floor, either side of the
cockpit in the cup holder inserts, and/or on the observer dash near the
glove box. A heater tube and vent is typically installed near the floor.
Operation
The heater’s three-position switch rotary control is turned left for
ON (LOW), or turned right for ON (HIGH). The heater can only be
operated with the engine ON. This is to prevent potential excessive
battery drain.
GLOVE BOX
Models
All
Purpose
The glove box provides easily accessible storage space for small
items. MasterCraft recommends that you keep this Owner’s Manual
in a water-resistant plastic bag inside the glove box so that it is
quick to find in the event that troubleshooting for any part of the
boat is required.
Location
The glove box is located on the port side of the dash, forward of the
observer seat.
Special Attention
In regular use, the heater should not require any routine
maintenance. However, it is advisable to avoid placing items in front
of the vents, particularly when the heater is in use. The heated air
coming out could cause damage.
Never run the heater in a confined space, such as a garage or shop.
Running the heater requires also running the engine; fumes from
the engine can be deadly. See also the Common Sense Approach in
the Safety section of this Owner’s Manual regarding carbon monox-
ide danger.
See the Storage and Winterization section of this Owner’s Manual
for winterization instructions.
Carbon monoxide is emitted from the engine’s exhaust system.
Never run the engine without proper ventilation. Do not run the
engine in a confined space or where fumes may be trapped.
Troubleshooting
If the heater fails to respond when the switch is turned to either of
its ON positions, check on the main circuit breaker panel to ensure
that the circuit has not tripped. If resetting does not correct the
problem or if it continues to trip, take the boat to an authorized
MasterCraft dealer for repair. While the air coming out of the vents
may be cool at first, if it does not warm up within a reasonable
period of time, take the boat to an authorized MasterCraft dealer.
Operation
Several dierent styles of glove box are featured, depending upon
the model. All have a closable lid. To open the glove box lids that
feature a recessed button, simply push in on the button and it will
pop up and twist to disengage the lid from the box.
Over stung a glove box can interfere with the lid latch’s ability to
close properly.
Special Attention
Glove box lids should always be closed and latched any time the
boat is in operation. While the boxes are water resistant, if the lid is
not latched securely water can intrude and cause damage to any-
thing inside the glove box. MasterCraft is not responsible for such
damage. Any items placed in the glove box that cannot or should
not become wet should be placed in water tight containers before
placing them inside the glove box.
Troubleshooting
Any time the lid will not close and latch properly, see an authorized
MasterCraft dealer. If it is not properly closed, damage could occur
to the lid.

MasterCraft NXT22 2017 Specifications

General

Brand	MasterCraft
Model	NXT22 2017
Category	Boat
Language	English