EasyManuals Logo
Home>MasterCraft>Boat>X46

MasterCraft X46 User Manual

MasterCraft X46
438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #346 background imageLoading...
Page #346 background image
BEFORE EACH USE
Before Starting the Engine
Review the engine manual before each outing to determine the
drive train requirements that need to be followed prior to each use.
Review the Safety Checks and Services section of this Owner’s
Manual. There are important functions that must be followed
before, during and after every outing, without fail!
Inspect the raw water intake water strainer for blockage. If
there is blockage, also check the transmission cooler (where
equipped).
Check and clean as necessary the seacock strainer.
Check the cooling system level. See the engine owner’s manual
for details.
Inspect the battery connections and hold-downs.
Inspect the drive train for loose or missing hardware.
Inspect the throttle and shift cables for kinks, wear and interfer-
ence with other components.
Inspect the propeller shaft log for excessive water entry.
Inspect the fuel system lines and connections for leaks.
Check for water leaks or excessive exhaust odor.
As you start the engine:
Check that the voltage reading registers a fully charged battery.
AFTER EACH USE
Refer to the Cleaning the Boat and Corrosion Prevention sections
of this Owner’s Manual for guidance on a thorough approach to
maintenance. Also pay attention to the information provided re-
garding the maintenance of Garapa Gold platforms and accessories
because the wood requires periodic maintenance as well.
Boats equipped with an optional flushing system for use in salt
water or brackish water should operate the flushing system.
Quarterly (Every Fifty [50] Hours)
Before Starting the Engine Or After It Has Cooled
Check the safety equipment.
Change the oil.
Annually (Every One Hundred [100] Hours)
NOTE: MasterCraft recommends that the following be performed
by authorized MasterCraft technicians at an authorized Master-
Craft dealer.
Before Starting the Engine Or After It Has Cooled
Replace the fuel filter (to be performed by an authorized Master-
Craft technician only).
Check the propeller shaft coupler alignment.
Lubricate the steering system.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MasterCraft X46 and is the answer not in the manual?

MasterCraft X46 Specifications

General IconGeneral
BrandMasterCraft
ModelX46
CategoryBoat
LanguageEnglish

Related product manuals