Matrix A5x-02 User Manual

43
8.16 PEDAL ARM REPLACEMENT
CHAPTER 8: PART REPLACEMENT GUIDE
1) Remove the plastic cover where the dual action handlebar meets the pedal arm (Figure A).
2) Remove the bolt and bushings where the dual action handlebar and the pedal arm meet (Figure B).
3) Remove the pedal as outlined in Section 9.15.
4) Remove the 3 bolts that hold on the mounting plate at the link arm / pedal arm joint (Figure C). Note the plastic washer that mounts at the end
of the shaft.
5) Slide the pedal arm shaft out of the link arm housing noting the order of the washers on the pedal arm shaft (Figure D).
6) Reverse Steps 1-5 to install a new pedal arm.
7) Test the Ascent Trainer for function as outlined in Section 9.19.
FIGURE A FIGURE B
FIGURE C FIGURE D

Matrix A5x-02 Specifications

General

Brand	Matrix
Model	A5x-02
Category	Elliptical Trainer
Language	English