29
8.5 ECB BELT REPLACEMENT
CHAPTER 8: PART REPLACEMENT GUIDE
1) Turn off the power and disconnect the cord from the machine.
2) Remove the front disks from the machine as outlined in Section 9.1.
3) Loosen the 6 bolts holding the ECB to the frame (Figure A).
4) Loosen the 11mm nut on the tension loop bolt until there is enough slack in the belt to remove it (Figure B).
5) Install the replacement belt and reverse necessary steps to secure the assembly until the belt is tight. Tighten the 6 ECB bolts to 12 N-m
torque. Tighten the ECB belt to 120 lbs.
6) Test the Ascent Trainer for function as outlined in Section 9.19. .
FIGURE A
FIGURE B
To Next Page
Loading...
Need help?
General
